Blower door testing helps us understand where structures leak and is the first step toward building tighter, more energy-efficient homes.
What is a blower door test?
The purpose of Blower Door Testing is to measure the air tightness of a home and check for air leakage. A blower door is a powerful fan that mounts into the frame of an exterior door. The fan pulls air out of the house, lowering the air pressure inside. The higher outside air pressure then flows in through all unsealed cracks and openings.
Image courtesy of energy.gov/.
These are some reasons for establishing the proper building tightness:
Reducing energy consumption from excess air leakage
Avoiding moisture condensation problems
Avoiding uncomfortable drafts caused by cold or warm air leaking in from outside
Controlling outdoor contaminants, pests, and odors from entering your home.
Determining proper sizing and airflow requirements of heating and cooling equipment.
Determining whether mechanical ventilation is needed to provide acceptable fresh air and maintain indoor air quality in your home.
Determine the air infiltration rate
While the blower test is being conducted, our insulation specialist may use an infrared camera to look at the walls, ceilings, and floors. Moreover, this test finds specific locations where insulation is missing and air is leaking.
Preparing for a blower door test
Our experienced insulation specialist performs the blower door test. This includes a walk-through of your home, setting up the blower door, and conducting the test. The following steps will help prepare your home for a blower door test:
Plan to do a walk-through of your home with the specialist. Be prepared to point out areas that you know are drafty or difficult to condition comfortably.
Expect the specialist to request access to all areas of your home including closets, built-in cabinets, attics, crawl spaces, and any unused rooms.
The specialist will need to close all exterior doors and windows, open all interior doors, and close any fireplace dampers, doors, and woodstove air inlets.
If you heat with wood, be sure all fires are completely out – not even coals – before the specialist arrives. Remove any ashes from open fireplaces.
Expect the specialist to set controls on all atmospheric fossil fuel appliances (e.g., furnace, water heater, fireplaces, and stoves) to ensure that they do not fire during the test. The specialist should return them to the original position after the test.
Expect the test to take up to an hour or more, depending on the complexity of your home.
The Green Cocoon offers custom, cost-effective solutions to make your home or office building more comfortable. Additionally, this saves you money on your energy bills. Our troubleshooting and diagnostic skills separate us from the pack! For more information, contact us
While the blower test is being conducted, our insulation specialist may use an infrared camera to look at the walls, ceilings, and floors. Moreover, this test finds specific locations where insulation is missing and air is leaking.
